VehiclesKyosho Outlaw Rampage PRO
Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Vehicle | ||
| Drive | 2WD | |
| Power | Motor not included | |
| Build | Roller / ARR | |
| Scale | 1/10 | |
| Part number | 34362C | |
| Drivetrain | ||
| Pinion | Not published | |
| Spur | Not published | |
| Transmission & axle | Not published | |
| Final drive | 12.65:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | 108mmStock | Stock |
| Rollout | 26.8mm per motor turnCalculated | Calculated |
| Power | ||
| Motor | Not applicable | |
| Battery | Not applicable | |
| Performance | ||
| Theoretical top speed | Not applicable | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not applicable means the vehicle does not come with it, like the motor on a roller or the tires on a race kit, or does not have one, like a KV rating on a brushed motor. Not published means it exists but no source we could find prints it.
How these numbers were settled
An assembled kit version of the earlier Outlaw Rampage PRO, released in September 2023 and since discontinued, now superseded by the PRO 2.0.
- Kyosho describes it as about 70 percent factory assembled.
- Kyosho's Technical Data gives a 12.65:1 gear ratio and a 108 by 38mm tire, with a weight of about 2,600 grams.
- The radio system, speed controller, motor and battery are sold separately, and no pinion, spur or transmission figures are printed.
Sources
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.