VehiclesRC4WD Trail Finder 2 LWB RTR 1987 Toyota XtraCab (White)

RC4WD Trail Finder 2 LWB RTR 1987 Toyota XtraCab (White)
1/10 scale · scale crawler · Z-RTR0064
- Final drive
- 31.93:1
- Tire
- 91.4mm

Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Drivetrain | ||
| Pinion | 14TStock | Stock |
| Spur | 64TStock | Stock |
| Transmission & axle | 6.99:1Derived | Derived |
| Spur ÷ pinion | 4.571:1Calculated | Calculated |
| Final drive | 31.93:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | 91.4mmEstimated | Estimated |
| Rollout | 9.0mm per motor turnCalculated | Calculated |
| Power | ||
| Motor | Not applicable | |
| Motor shaft | Not published | |
| Battery | Up to 3SLiPoStock | Stock |
| Performance | ||
| Theoretical top speed | Not applicable | |
| Vehicle | ||
| Part number | Z-RTR0064 | |
| Scale | 1/10 | |
| Class | Scale crawler | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Derived is worked out from gear tooth counts the maker publishes rather than printed as a ratio; the notes below say how. Not applicable means the vehicle does not come with it, like the motor on a roller or the tires on a race kit, or does not have one, like a KV rating on a brushed motor. Not published means it exists but no source we could find prints it.
Gearing parts
| Component | Teeth | Pitch | Bore | Part number |
|---|---|---|---|---|
| Fitted at the factory | ||||
| Pinion | 14T | 32P | Not published | Z-S0430 |
| Spur | 64T | Not published | Not applicable | Not published |
Tooth counts are the ones in the specifications above. Pitch is given as metric module (Mod 1, Mod 0.8) or diametral pitch (32P, 48P). They are different standards and are not interchangeable, even where the numbers look close. Bore is the pinion’s hole, listed separately from the motor shaft.
How these numbers were settled
The white XtraCab is a separate RTR from the black one (Z-RTR0057): it ships on different tires.
- RC4WD's specification as carried by RPP Hobby prints a 14/64 pinion and spur (4.57:1), the R3 transmission internal ratio, the Hammer transfer case at 1.47:1 and 15/40 axle gears at 2.67:1, the same driveline as the black edition, whose listing prints 1.78:1 for the transmission and a 31.93:1 total.
- The ratio after the spur is 1.78 x 1.47 x 2.67 = 6.99.
- The motor is a 45T brushed 540 can, so there is no KV.
- The replacement parts list names the tire as Z-T0107, the BFGoodrich All Terrain KO2 1.7; RC4WD's tire copy reproduced by RPP Hobby gives 'Outer Diameter: 3.59in / 91.4mm', so the diameter shows as estimated.
- The Outcry III ESC is rated '2-3S LiPo or 5-9 NiMH' in RC4WD's own ESC sheet; the truck ships with a 6-cell NiMH pack.
Documents
- ManualOwner's manual, TF2 LWB RTR 1987 Toyota XtraCab, white (RC4WD PDF) (opens in a new tab)Spare parts, p. 30 (PDF p. 31)
Sources
- rc4z-rtr0064rpphobby.com (opens in a new tab)
- rc4z-t0107rpphobby.com (opens in a new tab)
- rc4z-rtr0057rpphobby.com (opens in a new tab)
- Manual (PDF)rc4wd.com (opens in a new tab)
- Manual (PDF)rc4wd.com (opens in a new tab)
- rc4wd-14t-32p-hardened-stee…cmldistribution.co.uk (opens in a new tab)
- Manual (PDF)rc4wd.com (opens in a new tab)
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.
More from RC4WD
- Gelande II RTR Cruiser
- Gelande II RTR Cruiser (Red, Tomahawk tires)
- Marlin Crawler Trail Finder 2 RTR
- Trail Finder 2 LWB RTR 1987 Toyota XtraCab
- Trail Finder 2 LWB RTR Chevrolet K10 Scottsdale
- Trail Finder 2 LWB RTR Mojave II Four Door
- Trail Finder 2 RTR 1982 Toyota Pickup
- Trail Finder 2 RTR 1985 Toyota 4Runner