VehiclesKyosho Inferno MP10T
Kyosho Inferno MP10T
1/8 scale · stadium truck · 33017
- Final drive
- 16.30:1
Engine powered, so there is no motor KV: compare gearing by rollout.
Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Vehicle | ||
| Class | Stadium truck | |
| Drive | 4WD | |
| Power | Nitro | |
| Scale | 1/8 | |
| Part number | 33017 | |
| Drivetrain | ||
| Pinion | Not published | |
| Spur | Not published | |
| Transmission & axle | Not published | |
| Final drive | 16.30:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | Not applicable | |
| Power | ||
| Motor | Not applicable | |
| Battery | Not applicable | |
| Performance | ||
| Theoretical top speed | Not applicable | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not applicable means the vehicle does not come with it, like the motor on a roller or the tires on a race kit, or does not have one, like a KV rating on a brushed motor. Not published means it exists but no source we could find prints it.
How these numbers were settled
Kyosho's Inferno MP10T is a 1/8 scale nitro stadium truck kit built for a .21 to .28 class engine, with a sale date of October 2019 and later marked out of stock and discontinued.
- The Technical Data table gives a gear ratio of 16.3 to 1, and the engine, tires and transmitter are all sold separately.
- A pinion and spur tooth count were not published on the page found.
Sources
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.