VehiclesLosi DBXL 2.0 Gas (LOS05008)

Losi

Losi DBXL 2.0 Gas (LOS05008)

1/5 scale · buggy · LOS05008

Specs

The DBXL 2.0 Gas (LOS05008) is Losi's 1/5 four-wheel-drive desert buggy, sold ready to run with a Zenoah gas engine.

A 20T pinion on a 62T spur with 3.33:1 inside the transmission gives a final drive of 10.32:1, the number of engine turns for each turn of the wheels. Losi does not publish the tire diameter or a speed claim, so top speed is not worked out here. The buggy is 845 mm long on a 552 mm wheelbase with 24 mm wheel hexes, so check the fuel and two-stroke oil mix before the first run.

Final drive
10.32:1

Engine powered, so there is no motor KV: compare gearing by rollout.

Losi DBXL 2.0 Gas (LOS05008)
Photo: Horizon Hobby (opens in a new tab)

Specifications

Last modified

SpecValueBasis
Vehicle
ClassBuggy
Drive4WD
PowerGas
BuildReady to run
Scale1/5
Part numberLOS05008
Drivetrain
Pinion20TStockStock
Spur62TStockStock
Transmission & axle3.33:1StockStock
Final drive10.32:1StockStock
Wheels & tires
Tire diameterNot published
Wheel hex24 mmStockStock
Power
MotorNot applicable
Motor shaftNot applicable
BatteryNot applicable
Performance
Theoretical top speedNot applicable
Size & weight
Weight15.51 kg (34.2 lb)StockStock
Length845 mm33.3 inStockStock
Width495 mm19.5 inStockStock
Height318 mm12.5 inStockStock
Wheelbase552 mm21.7 inStockStock
How to read these figures
  • Stock is as the vehicle ships.
  • Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart.
  • Not applicable means the vehicle does not come with it, like the motor on a roller or the tires on a race kit, or does not have one, like a KV rating on a brushed motor.
  • Not published means it exists but no source we could find prints it.

Gearing dimensions

Pinion and spur dimensions for the Losi DBXL 2.0 Gas (LOS05008): fitted, and optional gearing supplied in the box
ComponentTeethPitchBore
Fitted at the factory
Pinion20TMod 1.5Not applicable
Spur62TMod 1.5Not applicable
About teeth, pitch and bore
  • Tooth counts are the ones in the specifications above.
  • Pitch is given as metric module (Mod 1, Mod 0.8) or diametral pitch (32P, 48P). They are different standards and are not interchangeable, even where the numbers look close.
  • Bore is the pinion’s hole, listed separately from the motor shaft.

How these numbers were settled

Losi's spec table prints a 20T pinion, a 62T spur, a 3.33:1 transmission and a 10.32:1 final drive, which agrees with 62/20 x 3.33.

  • The manual calls 20/62 the stock gearing, and its parts list names the 20T pinion as LOS252016 and the 62T 1.5M spur as LOS252132.
  • Losi prints no tire diameter for the Creepy Crawler LT tires, so it is left blank.
  • The buggy runs a Zenoah 32cc gas engine, so motor KV and cell count do not apply.

Sources

Every figure on this page traces to one of these; where they disagreed, the note above says which was used and why. Links open in a new tab.

Maker documents

2

This vehicle

1

Parts and electronics

2

Source details

More from Losi

All Losi vehicles