VehiclesWLtoys 104019

- Scale
- 1/10
- Drive
- 4WD
- Max LiPo
- -
- Power
- brushless
Background
The 104019 belongs to WLtoys' electrically powered ready-to-run range. Its defining equipment includes a 3660 brushless motor, four-wheel independent suspension and metal drivetrain gears. The 1/10 designation describes its marketed size, while the assembled dimensions are the better reference when checking storage space, a replacement body or room to drive. Vehicle information (opens in a new tab)
Read moreShow less
Its four-wheel-drive layout suits off-road use. The supplied power system is brushless, and the assembled package keeps the radio and vehicle together. A model-specific replacement list is useful when restoring an older example because body panels, steering parts and electronics can differ between numbered versions. Compare the fitted component and its connector before ordering a replacement. Equipment and configuration (opens in a new tab)
Specifications
| Spec | Value | Basis |
|---|---|---|
| Vehicle | ||
| ||
| Class | Monster truck | |
| Drive | 4WD | |
| Power | Brushless | |
| Build | Ready to run | |
| Scale | 1/10 | |
| Part number | 104019 | |
| Drivetrain | ||
| ||
| Pinion | Not published | |
| Spur | Not published | |
| Transmission & axle | Not published | |
| Final drive | Not published | |
| Wheels & tires | ||
| ||
| Tire diameter | Not published | |
| Power | ||
| ||
| Motor | Not published | |
| Battery | Not published | |
| Motor size | 3660canSingle report | Single report |
| Performance | ||
| ||
| Theoretical top speed | Not published | |
| Size & weight | ||
| ||
| Length | 380 mm15 inSingle report | Single report |
| Width | 275 mm10.8 inSingle report | Single report |
| Height | 195 mm7.7 inSingle report | Single report |
How to read these figures
- Stock is as the vehicle ships.
- Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart.
- Single report uses one outside source. It is useful as a starting figure, with the source and calculation described in the note.
- Not published means it exists but no source we could find prints it.
Build and setup
Factory setup guide for this configuration.
Service the 104019's steering saver before treating weak steering as a servo problem. Its factory drawing shows the 0270 sleeve, buffer spring, upper/lower steering arms and retaining E-clip as a separate assembly, alongside the servo and short link. Restore that stack and check the link ends for free movement before replacing the servo. Steering trim cannot correct a missing spring or a binding mechanical joint.[1] 104019 factory instruction/assembly manual (Hobbyteam mirror) (opens in a new tab)
The brushless truck's suspension and wheels have their own references. The handbook separates the 1972 front and 2233 rear damper assemblies, and shows the 2237 tire set in left- and right-hand arrangements. Keep those positions recorded when stripping the truck. Match the CVD, hub bearings and wheel-drive pin to the exact front assembly rather than assuming a nearby 104009 or crawler diagram is the same.[1] 104019 factory instruction/assembly manual (Hobbyteam mirror) (opens in a new tab)
OEM parts
Drivetrain
3Planetary gear shaft
Ball bearing, 5 x 10 x 4
Hardware & seals
9Round-head screw, 3 x 36
Round-head screw, 3 x 30
Round-head self-tapping screw, ST1.7 x 6
Round-head screw, 3 x 14
Round-head screw, M2.5 x 6 x 6
Washer set
Countersunk self-tapping screw, 2.6 x 8
Round-head self-tapping screw, 2.6 x 8
Unclassified
1R-type pin
13 collected part numbers. Collected . Unmarked parts are recorded listings, without a claim about factory installation; optional and upgrade listings are tagged. Key assemblies include recorded gear and shock identifiers. Open a part for its listing sources.
About these specs
Technical figures are attributed retailer information for this model. Battery size supplied in a package does not establish the maximum supported voltage.
Sources
5 source links for this model.
Read moreShow less
- Manuals.
- Vehicle product and specification pages.
- Individual part and electronics specifications.
Links open in a new tab.
Maker documents
1- 104019 instruction manual and parts diagrams (Hobbyteam factory scan) (opens in a new tab)Supports 1 specificationUsed forMain specs
This vehicle
1- WLtoys 104019 product page (opens in a new tab)Supports 1 specificationUsed forMain specs
Parts and electronics
3- Products details 79 (opens in a new tab)Supports 1 specificationUsed forMain specs
- Vehicle information (opens in a new tab)Supports 3 specificationsRetailer listingUsed forMain specsPowerDrivetrainBackground
- Prodetail RC car yppriugyvtki (opens in a new tab)Supports 1 specificationUsed forSize
