VehiclesHPI Racing Stage-D10 Flux
HPI Racing
HPI Racing Stage-D10 Flux
1/10 scale · 161007
- Final drive
- 7.70:1
- Tire
- 63mm
Open in Top Speedverified
Specifications
Last modified
| Spec | Value | Basis |
|---|---|---|
| Drivetrain | ||
| Pinion | 27TStock | Stock |
| Spur | 80TStock | Stock |
| Transmission & axle | 2.60:1Stock | Stock |
| Spur ÷ pinion | 2.963:1Calculated | Calculated |
| Final drive | 7.70:1Stock | Stock |
| Wheels & tires | ||
| Tire diameter | 63mmEstimated | Estimated |
| Rollout | 25.7mm per motor turnCalculated | Calculated |
| Power | ||
| Motor | Not published | |
| Battery | Up to 2SLiPoStock | Stock |
| Performance | ||
| Theoretical top speed | Not published | |
| Vehicle | ||
| Part number | 161007 | |
| Scale | 1/10 | |
Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not published means it exists but no source we could find prints it.
How these numbers were settled
2WD RWD drift.
- HPI's factory setup sheet prints pinion, spur and total together.
- Motor: FLX-D10 10.5T sensored Flux; HPI publishes no KV for it, so KV is left blank rather than guessed.
- Battery: 2S LiPo (XT-60), per the kit page.
- The gearbox is reconfigurable (3- or 4-gear); 7.7 is the as-delivered RTR setting.
Sources
- Manual (PDF)hpiracing.com (opens in a new tab)
- Manual (PDF)hpiracing.com (opens in a new tab)
- 161007hpiracing.com (opens in a new tab)
Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.