HPI Racing Stage-D10 Creator Edition

Stock is as the vehicle ships. Calculated is worked from the stock figures on this page rather than stored beside them, so the two cannot drift apart. Not applicable means the vehicle does not come with it, like the motor on a roller or the tires on a race kit, or does not have one, like a KV rating on a brushed motor.

Gearing parts

Tooth counts are the ones in the specifications above. Pitch is given as metric module (Mod 1, Mod 0.8) or diametral pitch (32P, 48P). They are different standards and are not interchangeable, even where the numbers look close. Bore is the pinion’s hole, listed separately from the motor shaft. Linked part numbers go to the maker's or official distributor's page for that part.

Buying a new pinion or spur? Check what’s fitted first: Why your RC's gear specs might not add up

How these numbers were settled

Pre-assembled 2WD drift chassis sold without a motor, speed control, pinion gear, wheels or tires, so the buyer's own choices decide those figures.

• The chassis itself carries a fixed 2.6 to 1 internal ratio and an 80-tooth spur gear, both from the platform's own technical guide.
• The gearbox can be run in a 3-gear or 4-gear configuration.

Sources

• 161000hpiracing.com (opens in a new tab)
• Manual (PDF)hpiracing.com (opens in a new tab)

Every figure on this page traces to one of these. Where they disagreed, the note above says which was used and why.

More from HPI Racing

• Sport 3 Creator Edition
• Sprint 2 Drift Sport
• Sprint 2 Flux
• Sprint 2 Sport
• Stage-D10 Flux
• Stage-D10 Ford Mustang RTR Spec 5-FD
• Venture FJ Cruiser
• Venture Scale Builder Kit