VehiclesTraxxas TRX-4M Chevrolet K10 High Trail EditionRadio binding
Maintenance reference
Radio binding
Traxxas TRX-4M Chevrolet K10 High Trail Edition · 97064-1
97064-1 exact RTR edition in archived manual
← Vehicle service referenceStart with the correct reference
Exact SET/EZ-Set binding procedure for the integrated ECM-2.5. Confirm both LEDs are solid green before checking steering and throttle.
- Exact radio binding, PDF p. 16 (opens in a new tab)
Manufacturer procedure · 97064-1 exact archived owner manual
- Radio-system power order and 20-second linking window, PDF p. 15 (opens in a new tab)
Manufacturer procedure · 97064-1 exact archived owner manual
Service guides
Choose the operation for the assembly being serviced. Each step links to its manufacturer reference.
Bind the original TQ with ECM-2.5 radio system
Traxxas TRX-4M Chevrolet K10 High Trail Edition, 97064-1, original TQ transmitter and ECM-2.5 combined control module. This binding sequence is separate from drive-profile selection.
Before starting
- Use new or freshly charged batteries for the radio system.Source, PDF p. 15 (opens in a new tab)
- Keep the transmitter and ECM within 5 feet of each other.Source, PDF p. 16 (opens in a new tab)
- During the sequence, the transmitter must be on before the vehicle battery is connected. The battery must be connected to the ECM within 20 seconds of switching on the transmitter.Source, PDF p. 15 (opens in a new tab)
Steps
- Press and hold SET on the transmitter.Source, PDF p. 16 (opens in a new tab)
- Switch on the transmitter, then release SET. The transmitter status LED flashes red slowly in bind mode.Source, PDF p. 16 (opens in a new tab)
- Hold EZ-Set on the ECM while plugging in the battery. Release EZ-Set when the ECM status LED flashes red.Source, PDF p. 16 (opens in a new tab)
- The ECM status LED flashes red slowly to indicate bind mode.Source, PDF p. 16 (opens in a new tab)
- Both the transmitter and ECM LEDs turn solid green when binding is complete.Source, PDF p. 16 (opens in a new tab)
Final checks
- Before driving, confirm that steering and throttle operate properly.Source, PDF p. 16 (opens in a new tab)
- If the 20-second linking window is missed, switch off the transmitter and start again.Source, PDF p. 15 (opens in a new tab)
- When finished, unplug the battery from the ECM, then switch off the transmitter.Source, PDF p. 15 (opens in a new tab)
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- Transmitter
- 2-Channel TQ 2.4 GHz Transmitter 2-channel, 2.4 GHz, 4 AAStock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.