VehiclesTraxxas TRX-4 with Deep-Terrain TraxxRadio binding
Maintenance reference
Radio binding
Traxxas TRX-4 with Deep-Terrain Traxx · 82234-4
82234-4 exact RTR edition in archived manual
← Vehicle service referenceStart with the correct reference
Exact SET/LINK binding procedure for this edition. Confirm solid green transmitter and receiver LEDs and check steering and throttle before driving.
- Transmitter and receiver binding, PDF p. 18 (opens in a new tab)
Manufacturer procedure · 82234-4 exact archived owner manual
- Radio-system power order and 20-second linking window, PDF p. 16 (opens in a new tab)
Manufacturer procedure · 82234-4 exact archived owner manual
Service guides
Choose the operation for the assembly being serviced. Each step links to its manufacturer reference.
Bind the original TQ 2.4GHz radio system
Traxxas TRX-4 with Deep-Terrain Traxx, 82234-4, original TQ 2.4GHz transmitter and receiver covered by this exact manual edition. This is radio binding, not ESC throttle calibration.
Before starting
- Use new or freshly charged batteries for the radio system.Source, PDF p. 16 (opens in a new tab)
- For binding, the receiver requires a 4.8-6.0V nominal power source. Keep the transmitter and receiver within 5 feet of each other.Source, PDF p. 18 (opens in a new tab)
- During the sequence, the transmitter must be on before the vehicle battery is connected. The receiver must be switched on within 20 seconds of switching on the transmitter.Source, PDF p. 16 (opens in a new tab)
Steps
- Press and hold SET on the transmitter.Source, PDF p. 18 (opens in a new tab)
- Switch on the transmitter, then release SET. The transmitter status LED flashes red slowly in bind mode.Source, PDF p. 18 (opens in a new tab)
- Connect the vehicle battery to the speed control.Source, PDF p. 16 (opens in a new tab)
- Press and hold LINK on the receiver.Source, PDF p. 18 (opens in a new tab)
- Press EZ-Set on the speed control to switch on the model, then release LINK.Source, PDF p. 18 (opens in a new tab)
- Both the transmitter and receiver LEDs turn solid green when binding is complete.Source, PDF p. 18 (opens in a new tab)
Final checks
- Before driving, confirm that steering and throttle operate properly.Source, PDF p. 18 (opens in a new tab)
- If the 20-second linking window is missed, switch off the transmitter and start again.Source, PDF p. 16 (opens in a new tab)
- When finished, switch off the model before switching off the transmitter.Source, PDF p. 16 (opens in a new tab)
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- Transmitter
- Traxxas TQ 2-channel, 2.4 GHzStock
- Receiver
- Traxxas TQ 3-channel, 2.4 GHzStock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.