Search Team Associated Pro2 SC10

Explore the catalog

VehiclesTeam Associated Pro2 SC10ESC calibration

Maintenance reference

ESC calibration

Team Associated Pro2 SC10 · 70020

Exact 70020 product selector explicitly links this component edition, captured identical checked bytes.

← Vehicle service reference

Start with the correct reference

For installed SC600-BL after ESC/radio or endpoint changes: endpoints 100%, neutral trim; hold SET at power-on and save neutral/full throttle/maximum brake. RTR ESC already calibrated.

Reedy SC600-BL: calibration

Pro2 SC10 (70020), exact documented installation and manual edition; confirm any fitted-component condition listed before starting.

Before starting

  • Confirm the fitted controller is SC600-BL. RTR installations are factory-calibrated; recalibrate after replacing the ESC or transmitter or changing neutral, ATV or EPA.
  • Use the correct battery mode. At neutral, green indicates LiPo and red indicates NiMH.

Calibration sequence

  1. Set throttle and brake EPA/ATV to 100%, center throttle trim and turn on the transmitter.
  2. Hold SET while switching on the ESC, then release SET immediately when the LED starts flashing.
  3. At neutral, press SET. One LED flash confirms the saved neutral point.
  4. At full throttle, press SET. Two LED flashes confirm the saved throttle endpoint.
  5. At maximum brake, press SET. Three LED flashes confirm the saved brake endpoint.
  6. Return to neutral. After three seconds the ESC exits calibration and is ready.

Final checks

  • Recheck the battery mode at neutral before driving. LiPo requires LiPo mode.
  • Switch the ESC off before switching off the transmitter.
Reedy SC600-BL manual: throttle calibration, PDF p. 2

Parts, tools and consumables

No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

ESC
Reedy SC600-BLStock
Sources
ESC mounting method
Servo tape #6727. Original assembly drawing places tape beneath the ESC; receiver and battery attachments are separate.Stock
Sources
ESC mounting dimensions
48.5 × 36 × 32. Original SC600-BL case envelope, not screw-hole spacing or tray clearance. OEM manual gives 36 mm width; 2015 news gives 38 mm. mm, maker listed dimension orderStock
Sources
ESC motor connector
3.5 mm sockets. Original SC600-BL motor outputs; T-plug battery input is separate.Stock
Sources
Battery connector
T-PlugStock
Sources

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.