VehiclesLosi 5IVE-TE 3.0 Electric 4WD Desert Truck RTRESC calibration
Maintenance reference
ESC calibration
Losi 5IVE-TE 3.0 Electric 4WD Desert Truck RTR · LOS05022
LOS05022 5IVE-TE 3.0 Electric 4WD Desert Truck RTR
← Vehicle service referenceStart with the correct reference
Manufacturer procedure for this exact configuration. Follow the cited sequence and its conditions.
- ESC endpoint calibration, PDF p. 9 (opens in a new tab)
Manufacturer procedure · LOS05022 exact maker-attached manual
Firma 250 throttle calibration: calibration
Losi 5IVE-TE 3.0 Electric 4WD Desert Truck RTR (LOS05022), exact factory configuration covered by the cited manual edition.
Before starting
- Confirm LOS05022 and the factory Firma 250 ESC. Bind the transmitter and receiver first.
Calibration sequence
- Set throttle travel to 100%, throttle trim to neutral, and the brake-rate knob to 100%.
- Switch on the transmitter, then connect the battery with the ESC still off.
- Hold SET while switching on the ESC. Release when the red LED flashes, before three seconds. Green flashing is programming mode; power off and repeat.
- At neutral press SET; expect one green flash and one motor tone.
- At full throttle press SET; expect two green flashes and two tones.
- At full brake press SET; expect three green flashes and three tones.
Final checks
- Normal motor operation resumes after calibration.
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- ESC
- Spektrum Firma 250A Brushless Smart ESC, 6S-12SStock
- ESC rating
- 250 A continuousStock
- Battery connector
- IC5Stock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.