VehiclesElement RC Enduro Zuul IFS2Shock service
Maintenance reference
Shock service
Element RC Enduro Zuul IFS2 · 40127
Enduro Zuul IFS2 (40127), manual shock assembly
← Vehicle service referenceStart with the correct reference
Shock assembly and bleeding sequence. Follow this edition for cap design and front/rear configuration; no universal replacement basket is established.
- Shock assembly and bleeding, PDF p. 13 (opens in a new tab)
Manufacturer procedure · Enduro Zuul IFS2 40127 manual
Parts, tools and consumables
Required by the instructions
- Shock fluid specified for this shock and axle configurationconsumable
During filling and bleeding; use the exact manual configuration.
Requirement source, PDF p. 13 (opens in a new tab)
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- Shocks
- Oil-filled threaded, aluminum body, 3 mm shaft, front and rearStock
- Shock bore
- 10 mm, front and rear; Nominal bore estimate from the OEM body size designation; internal diameter is not separately stated.Derived from replacement part
- Spring, front
- Gray, 1.49 lb/in, 63mmStock
- Spring, rear
- Blue, 2.09 lb/in, 63mmStock
- Front upper shock bolt
- 3 × 20 LP SHCS. Original #41091; fastener at this mount; not an internal shock-eye thread. mmStock
- Rear upper shock bolt
- 3 × 20 LP SHCS. Original #41091; fastener at this mount; not an internal shock-eye thread. mmStock
- Front lower shock bolt
- 3 × 16 set screw. Original #4689; set-screw mounting; not a conventional headed through bolt. mmStock
- Rear lower shock bolt
- 3 × 18 BHCS. Original #2308; fastener at this mount; not an internal shock-eye thread. mmStock
- Shock oil, front
- 30 wtStockConvert fluid grade
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.