Search Element RC Enduro SE Sendero

Explore the catalog

VehiclesElement RC Enduro SE SenderoUpgradesStealth XF slipper lockout

Stealth XF slipper lockout

Element RC Enduro SE Sendero · 40107

The lockout removes the slip clutch so drive reaches the transmission without deliberate clutch slip. It gives a direct drive connection, but transfers shock loads to the rest of the drivetrain and does not add overdrive.

← Back to vehicle upgrades

Parts & installation

Manufacturer documented
Vehicle
Element RC Enduro SE Sendero40107
Position
center
Change
Replace the slipper friction assembly with the factory 42333 locking plates.

Parts needed

Sold packages for one stated conversion
PartQty
42333FT Enduro SE, Stealth XF Slipper Lockout1

Element documents this configuration and the stated parts. Check your fitted transmission, axle and wheelbase before ordering.

Installation notes

  • Use the 42333 lockout plates around the retained 50T 42316 spur, following the Builder Kit 3 gate 04 arrangement. Remove both original slipper plates, two friction pads and three conical washers from the stock slipper stack; retain the correct shaft, nut and spur interface.
  • The original slip-clutch adjustment and protection no longer apply after lockout. Check free rotation, motor gear mesh and retained nut engagement; do not compensate for binding by tightening the assembly.
  • The stock SE and Utron have a functioning slipper. Builder Kit 3 and the complete 42337 transmission already include the lockout, so it is not an additional feature on those packages.

Sources

Element Enduro SE Sendero assembly manual
  • Maker instructions and assembly diagrams for the stated parts and configuration.
Element Enduro Builder Kit 3 assembly manual
  • Maker instructions and assembly diagrams for the stated parts and configuration.
Factory Team 42333 slipper lockout
  • Maker product information, applicable models and supporting parts.