VehiclesTraxxas TRX-4 Ford BroncoRadio binding
Maintenance reference
Radio binding
Traxxas TRX-4 Ford Bronco · 92076-4
92076-4 exact RTR edition in archived manual
← Vehicle service referenceStart with the correct reference
Exact SET/LINK binding procedure for this edition. Confirm solid green transmitter and receiver LEDs and check steering and throttle before driving.
- Transmitter and receiver binding, PDF p. 17 (opens in a new tab)
Manufacturer procedure · 92076-4 exact archived owner manual
- Radio-system power order and 20-second linking window, PDF p. 15 (opens in a new tab)
Manufacturer procedure · 92076-4 exact archived owner manual
Service guides
Choose the operation for the assembly being serviced. Each step links to its manufacturer reference.
Bind the original TQi radio system
Traxxas TRX-4 Ford Bronco, 92076-4, original TQi transmitter and receiver covered by this exact manual edition. This is radio binding, not ESC throttle calibration.
Before starting
- Use new batteries for the radio system.Source, PDF p. 15 (opens in a new tab)
- For binding, the receiver requires a 4.8-6.0V nominal power source. Keep the transmitter and receiver within 5 feet of each other.Source, PDF p. 17 (opens in a new tab)
- During the sequence, the transmitter must be on before the vehicle battery is connected. The receiver must be switched on within 20 seconds of switching on the transmitter.Source, PDF p. 15 (opens in a new tab)
Steps
- Hold SET on the transmitter while switching it on. Its LED flashes red slowly; release SET.Source, PDF p. 17 (opens in a new tab)
- Connect the vehicle battery to the speed control.Source, PDF p. 15 (opens in a new tab)
- Hold LINK on the receiver while pressing EZ-Set on the speed control to switch on the model. Release LINK.Source, PDF p. 17 (opens in a new tab)
- Both the transmitter and receiver LEDs turn solid green when binding is complete.Source, PDF p. 17 (opens in a new tab)
Final checks
- Before driving, confirm that steering and throttle operate properly.Source, PDF p. 17 (opens in a new tab)
- If the 20-second linking window is missed, switch off the transmitter and start again.Source, PDF p. 15 (opens in a new tab)
- When finished, switch off the model before switching off the transmitter.Source, PDF p. 15 (opens in a new tab)
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- Transmitter
- Traxxas 6530X 4-channel, 2.4 GHz, 30 model memory, 4 AAStock
- Receiver
- 5-Channel TQi 2.4 GHz Receiver with TSM 5-channel, 2.4 GHz, telemetry capableStock
- Receiver stability support
- Traxxas Stability Management (TSM)Stock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.