ESC calibration

Start with the correct reference

Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.

• Original ESC throttle calibration, PDF p. 18 (opens in a new tab)

  Manufacturer procedure · ZP5013_58076-74-OM-EN-R02.pdf

Parts, tools and consumables

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

ESC

VXL-3sStock

Sources

• Source 1: traxxas.com (opens in a new tab)

ESC rating

200 A continuousStock

Sources

• Source 1: rc4max.com (opens in a new tab)

ESC motor connector

3.5 mm bullet. Motor connection; nominal bullet size only where stated.Stock

Sources

• Source 1: traxxas.com (opens in a new tab)

ESC mounting dimensions

Case: 1.54 inches (39 mm) / 2.18 inches (55 mm) / 1.30 inches (33 mm). Supplied ESC case envelope, in printed order; mounting-hole spacing and bay clearance unspecified.Stock

Sources

• Source 1: traxxas.com (opens in a new tab)

ESC mounting method

Two 3 × 15 mm screws. Original 58076-74 installation; screw spacing and available clearance are not specified.Stock

Sources

• Source 1: traxxas.com (opens in a new tab)

Battery connector

Traxxas High-CurrentStock

Sources

• Source 1: traxxas.com (opens in a new tab)

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.