VehiclesRedcat Racing Machete 6SUpgradesCastle power-system component option

Castle power-system component option

Redcat Racing Machete 6S · RER17064

Castle names this family combination at a 16T pinion on 6S. Motor is 40 mm diameter (41.4 mm over fins), 75.4 mm long, 5 mm shaft; ESC is 53 x 49 x 36.4 mm. Supply a suitable high-current battery connector and verify mount/clearance, sensor-wire routing and BEC setting. Speed is a supplier estimate, not a measured result.

← Back to vehicle upgrades

Parts & installation

Manufacturer documented

Vehicle: Redcat Racing Machete 6SRER17064
Position: center
Change: Replace the original motor and ESC with the manufacturer-listed Castle combo.

Parts needed

Sold packages; retained hardware is stated separately

Part	Qty
010-0145-06Mamba Monster X ESC and 1515-2200Kv V2 sensored motor combo	1

Castle-recommended power-system option. Battery connectors, installation clearance and calibration remain build-specific; this is not a complete fitting guide.

Installation notes

This is an electronics component offering. Mounting, wiring and calibration must be checked for the actual vehicle; a full installed conversion recipe is not claimed.
Retain conservative gearing initially, verify motor/ESC temperatures, and match battery voltage to the motor package limit rather than the ESC-only headline.

Sources

Redcat Machete 6s™ / Castle Creations

The 16T/6S setup and approximate speed are supplier estimates, not measured performance or a completed vehicle fit check.

SURFACE ESC, MOTOR COMBO: MONSTER X 25.2V ESC, 8A PEAK BEC w/ 1515-220 / Castle Creations

The 1515V2 motor/MonsterX package still requires suitable battery connectors and mounting checks. Supplier performance descriptions are not measured results.