Shock service

Start with the correct reference

Manufacturer procedure for this exact configuration. Follow the cited sequence and its conditions.

• Shock reference, PDF p. 7 (opens in a new tab)

  Manufacturer procedure · LOS01016 exact maker-attached manual

Parts, tools and consumables

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

Shocks, front

Oil-filled threaded, 2 mm shaft; MEUS describes the original LOS213000 shaft as 2.0 mm when comparing its 2.5 mm upgrade. The exact OEM front assembly is shared; this is not the replacement shaft diameter.Aftermarket spec

Sources

• Source 1: losi.com (opens in a new tab)
• Source 2: meusracing.com (opens in a new tab)
• Source 3: horizonhobby.com (opens in a new tab)

Shocks, rear

Oil-filled threadedStock

Sources

• Source 1: losi.com (opens in a new tab)

Shock bore

7 mm, front and rearStock

Sources

• Source 1: losi.com (opens in a new tab)

Shock length, front

50 mm listed length; Approximate 50 mm hole-to-hole length of the MEUS replacement for LOS213000; supplied hardware and 2.5 mm shafts differ from stock. Working replacement reference, not an OEM shock measurement.Derived from replacement part

Sources

• Source 1: meusracing.com (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Shock oil, front

22.5 wtStockConvert fluid grade

Sources

• Source 1: horizonhobby.com (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Shock oil, rear

22.5 wtStockConvert fluid grade

Sources

• Source 1: horizonhobby.com (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.