Shock service

Start with the correct reference

Separate drawings identify the internal-spring and damping shocks. The rebuild set is listed for LMT 2.0; a complete fluid-change procedure is not indexed here.

• LMT 2.0 shock drawings, PDF p. 76 (opens in a new tab)

  Assembly drawing · LOS04028_MANUAL_MULTI.pdf

  An assembly drawing shows the components; it does not provide a complete service sequence.
• LMT 2.0 shock rebuild set, PDF p. 77 (opens in a new tab)

  Parts reference · LOS04028_MANUAL_MULTI.pdf

Parts, tools and consumables

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

Shocks

3.5 mm shaft 4 shocks, front and rear; Original diameter in GPM's comparison: 3.5mm stock, 4.0mm upgraded. This is a source-reported stock reference, not a measurement of the replacement shaft.Single report

Sources

• Source 1: gpmrcparts.com (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Spring, front

LOS-1842 internal spring, 1.8 lb (maker grade) Primary internal-spring unit; separate dampers are also fitted. The printed lb grade is not converted to lb/in.Stock

Sources

• Source 1: horizonhobby.com (opens in a new tab)

Spring, rear

LOS-1843 internal spring, 2.0 lb (maker grade) Primary internal-spring unit; separate dampers are also fitted. The printed lb grade is not converted to lb/in.Stock

Sources

• Source 1: horizonhobby.com (opens in a new tab)

Front shock lengths

130mm without internal spring / 134mm with internal spring. Listed center-to-center; two shock types at each axle; GPM replacement dimensionsDerived from replacement part

Sources

• Source 1: gpmrcparts.com (opens in a new tab)

Rear shock lengths

130mm without internal spring / 134mm with internal spring. Listed center-to-center; two shock types at each axle; GPM replacement dimensionsDerived from replacement part

Sources

• Source 1: gpmrcparts.com (opens in a new tab)

Front upper shock mount

Dual shock cap clamp (LOS-1806). Original factory assembly; the cap is captured by the split mount. Mount-to-chassis screws are separate from a through-eye shock bolt.Stock

Sources

• Source 1: horizonhobby.com (opens in a new tab)

Rear upper shock mount

Dual shock cap clamp (LOS-1806). Original factory assembly; the cap is captured by the split mount. Mount-to-chassis screws are separate from a through-eye shock bolt.Stock

Sources

• Source 1: horizonhobby.com (opens in a new tab)

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.