Search Losi LMT 2.0 Solid Axle Monster Truck

Explore the catalog

VehiclesLosi LMT 2.0 Solid Axle Monster TruckESC calibration

Maintenance reference

ESC calibration

Losi LMT 2.0 Solid Axle Monster Truck · LOS04028T1

Losi LMT 2.0 Solid Axle Monster Truck, LOS04028T1; original equipment covered by the cited edition.

← Vehicle service reference

Start with the correct reference

Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.

Firma 130 Black Edition throttle calibration: calibration

Losi LMT 2.0 Solid Axle Monster Truck (LOS04028T1), exact factory configuration covered by the cited manual edition.

Before starting

  • Confirm the factory ESC and exact manual edition. Complete transmitter/receiver binding first.

Calibration sequence

  1. Set throttle travel to 100% and center throttle trim.
  2. Switch on the transmitter and connect the battery with the ESC still off.
  3. Hold ESC SET while switching the ESC on. Release SET when the red LED flashes, before three seconds. If the LED flashes green, switch off and repeat; green indicates programming mode.
  4. With the trigger neutral, press and release SET. The red LED stops flashing, the green LED flashes once and the motor gives one tone.
  5. Hold full throttle and press SET. The green LED flashes twice and the motor gives two tones.
  6. Hold full brake and press SET. The green LED flashes three times and the motor gives three tones.

Final checks

  • The manual states that normal motor operation resumes after calibration. Disconnect the battery after use.
LOS04028_MANUAL_MULTI.pdf, PDF p. 14

Parts, tools and consumables

Required by the instructions

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

ESC
Firma 130 Black Edition Brushless Smart ESC, 2S-4SStock
Sources
ESC rating
130 A continuousStock
Sources
ESC mounting dimensions
56 × 36 × 38. OEM LMT 2.0 Black Edition ESC component size; tab span, hole spacing and chassis clearance are separate. mm (L × W × H)Stock
Sources
ESC motor connector
4 mm bullet. Original LMT 2.0 Black Edition ESC motor output; battery connector is separate.Stock
Sources
Battery connector
IC5Stock
Sources

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.