VehiclesElement RC Enduro Utron SEShock service
Maintenance reference
Shock service
Element RC Enduro Utron SE · 40108
Enduro Utron SE (40108), manual shock assembly
← Vehicle service referenceStart with the correct reference
Shock assembly and bleeding sequence. Follow this edition for cap design and front/rear configuration; no universal replacement basket is established.
- Shock assembly and bleeding, PDF p. 13 (opens in a new tab)
Manufacturer procedure · Enduro Utron SE 40108 manual
Parts, tools and consumables
Required by the instructions
- Shock fluid specified for this shock and axle configurationconsumable
During filling and bleeding; use the exact manual configuration.
Requirement source, PDF p. 13 (opens in a new tab)
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- Shocks
- Oil-filled threaded, composite body, 3 mm shaft, front and rearStock
- Shock length
- 90 mm listed length, front and rearStock
- Spring
- 42313 Shock Spring (mini springs) front and rearStock
- Front upper shock bolt
- 3 × 16 BHCS. Original #89203; fastener at this mount; not an internal shock-eye thread. mmStock
- Rear upper shock bolt
- 3 × 16 BHCS. Original #89203; fastener at this mount; not an internal shock-eye thread. mmStock
- Front lower shock bolt
- 3 × 16 set screw. Original #4689; set-screw mounting; not a conventional headed through bolt. mmStock
- Rear lower shock bolt
- 3 × 30 BHCS. Original #91478; fastener at this mount; not an internal shock-eye thread. mmStock
- Shock oil, front
- 30 wtStockConvert fluid grade
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.