Servo service

Start with the correct reference

Transmitter steering travel programming sequence. This is a travel adjustment, not an AS-1 servo rebuild or rear-steering calibration procedure.

• SLT3 steering travel adjustment reference, PDF p. 6 (opens in a new tab)

  Manufacturer procedure · AXI00003 exact archived manual

Parts, tools and consumables

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

Steering servo

Axial AS-1 Micro Servo (x2) plastic gear; OZRC-listed original AS-1 gear material; exact vehicle component mapping is separately established.Single report

Sources

• Source 1: horizonhobby.com (opens in a new tab)
• Source 2: ozrc.com.au (opens in a new tab)

Servo torque

18 oz-in at 6.0 V (1.3 kg-cm); OZRC-listed AXI31619 component torque at 6 V; not a tested result or confirmed installed BEC voltage.Single report

Sources

• Source 1: ozrc.com.au (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Stock servo spline

24. Original AS-1 AXI31619 micro spline, as specified by PowerHobby. Tooth count alone does not establish horn fitment. teethAftermarket spec

Sources

• Source 1: powerhobby.com (opens in a new tab)
• Source 2: horizonhobby.com (opens in a new tab)

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.