VehiclesArrma Vorteks 223S BLX DSC 2WDESC calibration
Maintenance reference
ESC calibration
Arrma Vorteks 223S BLX DSC 2WD · ARA3505
Arrma Vorteks 223S BLX DSC 2WD, ARA3505; original equipment covered by the cited edition.
← Vehicle service referenceStart with the correct reference
Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.
- Original ESC throttle calibration, PDF p. 20 (opens in a new tab)
Manufacturer procedure · ARA3505; ARA3505-MANUAL-ML.pdf
Vorteks 223S BLX DSC 2WD combined binding and throttle calibration: calibration
Original SPMXSE4510RX integrated 45A ESC/receiver and SPMRSLT270 transmitter in ARA3505. This exact edition documents combined binding and throttle calibration.
Before starting
- Confirm the installed integrated ESC/receiver and transmitter match this exact edition. Keep the wheels clear of the ground. Start with the controller and transmitter off.
Calibration sequence
- Connect a fully charged compatible battery to the ESC.
- Hold the controller bind button and press its power button. Release bind when its red LED flashes.
- Switch the transmitter on. The ESC LED changes to blue.
- Move the transmitter to full throttle and check one blue ESC flash.
- Move to full brake and check one blue ESC flash.
- Move the steering fully right and check one blue ESC flash.
- Move the steering fully left and check one blue ESC flash; the wheels turn left.
- Return the transmitter controls to neutral. Switch the ESC off, then switch the transmitter off.
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- ESC
- Spektrum SLT 45A 2-in-1 Waterproof ESC & Receiver 2S/3S with DSCStock
- ESC rating
- 45 A continuousStock
- ESC motor connector
- 4 mm bullet. Original supplied 2-in-1 ESC/receiver motor output; battery and servo connections are separate.Stock
- Battery connector
- IC5Stock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.