VehiclesArrma Mojave 6S BLX V3ESC calibration
Maintenance reference
ESC calibration
Arrma Mojave 6S BLX V3 · ARA7604V3
Arrma Mojave 6S BLX V3, ARA7604V3; original equipment covered by the cited edition.
← Vehicle service referenceStart with the correct reference
Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.
- Throttle setup, PDF p. 19 (opens in a new tab)
Manufacturer procedure · ARA7604V3_MANUAL_ML.pdf
Mojave 6S BLX V3 throttle setup: calibration
Original Firma 150A Smart V2 in ARA7604V3. Exact archived owner edition only; later firmware, other editions and replacement units require their own review.
Before starting
- Confirm that the vehicle still has the controller covered by this exact manual edition.
- Raise the wheels clear of the ground when checking the radio equipment. Use a fully charged compatible LiPo battery.
Calibration sequence
- With the ESC off, connect the battery and turn on the transmitter. Hold the ESC SET button while switching the ESC on. Release SET when the red ESC light flashes.
- With the transmitter trigger at neutral, press SET. The ESC gives one green flash.
- Hold full throttle and press SET. The ESC gives two green flashes.
- Hold full brake and press SET. The ESC gives three green flashes.
- Switch the ESC off to finish the setup.
Parts, tools and consumables
Required by the instructions
- Place the vehicle off the groundprerequisiteRequirement source, PDF p. 19 (opens in a new tab)
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- ESC
- Spektrum Firma 150A Smart V2 Waterproof ESC 4S/6SStock
- ESC rating
- 150 A continuousStock
- ESC mounting dimensions
- 58 × 47.5 × 38.5; width with tabs 59.5. OEM original ESC body envelope and tab span. Hole spacing, cable bends and available chassis clearance are separate. mm (L × W × H)Stock
- Battery connector
- IC5Stock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.