Shock service

Arrma Mojave 6S BLX EXB · ARA7704V3

Arrma Mojave 6S BLX EXB, ARA7704V3; original equipment covered by the cited edition.

← Vehicle service reference

Start with the correct reference

Manufacturer inspection and maintenance guidance. Detailed removal and rebuild steps are not indexed from this page.

Regular maintenance, PDF p. 24 (opens in a new tab)
Maintenance guidance · ARA7704V3-MANUAL-ML.pdf

Parts, tools and consumables

Replace or use as needed

Shock sealspart
Replace when wear compromises damping.
Requirement source, PDF p. 24 (opens in a new tab)

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

Shocks: Oil-filled aluminum body, emulsion, 4 mm shaft, front and rearStock
Sources
Source 1: horizonhobby.com (opens in a new tab)
Source 2: horizonhobby.com (opens in a new tab)
Source 3: horizonhobby.com (opens in a new tab)
Source 4: horizonhobby.com (opens in a new tab)
Source 5: horizonhobby.com (opens in a new tab)
Shock bore: 16 mm, front and rearStock
Sources
Source 1: horizonhobby.com (opens in a new tab)
Source 2: horizonhobby.com (opens in a new tab)
Shock length: 132 mm listed length, front and rearSingle report
Sources
Source 1: jennysrc.com (opens in a new tab)
Source 2: jennysrc.com (opens in a new tab)
Front lower shock bolt: 3 × 21.5mm shock mount pin (AR330231). Stock dedicated shock mount pin; retain its shoulder and threaded-tip geometry.Stock
Sources
Source 1: horizonhobby.com (opens in a new tab)
Source 2: rc4max.com (opens in a new tab)
Rear lower shock bolt: 3 × 21.5mm shock mount pin (AR330231). Stock dedicated shock mount pin; retain its shoulder and threaded-tip geometry.Stock
Sources
Source 1: horizonhobby.com (opens in a new tab)
Source 2: rc4max.com (opens in a new tab)
Front upper shock mount: ARA-4299 standoff; AR708001 nut. Stock standoff/nut assembly. A separate ordinary upper-bolt length is not established.Stock
Sources
Source 1: horizonhobby.com (opens in a new tab)
Rear upper shock mount: ARA-4299 standoff; AR708001 nut. Stock standoff/nut assembly. A separate ordinary upper-bolt length is not established.Stock
Sources
Source 1: horizonhobby.com (opens in a new tab)

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.