Search Arrma Kraton 6S BLX V5

Explore the catalog

VehiclesArrma Kraton 6S BLX V5ESC calibration

Maintenance reference

ESC calibration

Arrma Kraton 6S BLX V5 · ARA8608V5

Arrma Kraton 6S BLX V5, ARA8608V5; original equipment covered by the cited edition.

← Vehicle service reference

Start with the correct reference

Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.

Spektrum Firma 150A, ARRMA 6S V5: calibration

Original Firma 150A Smart ESC in the retained ARRMA6SV5 edition linked by ARA8608V5, ARA8611V5 ARA7604V2 and ARA8606V5. Firmware and later editions are outside this record.

Before starting

  • Confirm that the vehicle still has the controller covered by this exact manual edition.
  • Raise the wheels clear of the ground when checking the radio equipment. Use a fully charged compatible LiPo battery.

Calibration sequence

  1. With the ESC off, connect the batteries and switch on the transmitter.
  2. Hold the SET button while switching on the ESC. Release SET when the red ESC LED starts flashing.
  3. Leave the trigger at neutral and press SET. Confirm one green flash.
  4. Hold full forward throttle and press SET. Confirm two green flashes.
  5. Hold full brake and press SET. Confirm three green flashes.
  6. Switch off the ESC to finish the setup.

Final checks

  • Return the trigger to neutral before switching on for use.
ARA8608V5; ARRMA-6SV5-Manual-MULTI.pdf, PDF p. 12

Parts, tools and consumables

No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

ESC
Spektrum Firma 150A Smart 4S/6S ESCStock
Sources
ESC rating
150 A continuousStock
Sources
ESC mounting dimensions
58 × 47.5 × 38.5; width with tabs 59.5. OEM original ESC body envelope and tab span. Hole spacing, cable bends and available chassis clearance are separate. mm (L × W × H)Stock
Sources
ESC mounting method
Screw-retained tray and side supports (AR320430). Original tray assembly shown for this edition; replacement ESC dimensions and hole spacing are separate.Stock
Sources
Battery connector
IC5Stock
Sources

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.