VehiclesArrma Kraton 6S EXBESC calibration
Maintenance reference
ESC calibration
Arrma Kraton 6S EXB · ARA8708V6T1
Arrma Kraton 6S EXB, ARA8708V6T1; original equipment covered by the cited edition.
← Vehicle service referenceStart with the correct reference
Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.
- ESC throttle setup, PDF p. 11 (opens in a new tab)
Manufacturer procedure · ARA8708V6T1; ARA8708V6_MANUAL_ML.pdf
Kraton 6S EXB throttle setup: calibration
Original Firma SPMXSE2150 in ARA8708V6T1. Exact archived owner edition only; later firmware, other editions and replacement units require their own review.
Before starting
- Confirm that the vehicle still has the controller covered by this exact manual edition.
- Raise the wheels clear of the ground when checking the radio equipment. Use a fully charged compatible LiPo battery.
Calibration sequence
- With the ESC off, connect the battery and turn on the transmitter. Hold the ESC SET button while switching the ESC on. Release SET when the red ESC light flashes.
- With the transmitter trigger at neutral, press SET. The ESC gives one green flash.
- Hold full throttle and press SET. The ESC gives two green flashes.
- Hold full brake and press SET. The ESC gives three green flashes.
- Switch the ESC off to finish the setup.
Parts, tools and consumables
No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.
Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.
Setup specifications
- ESC
- Spektrum Firma 150A Smart V2 Brushless 6S ESCStock
- ESC rating
- 150 A continuousStock
- ESC mounting dimensions
- 58 × 47.5 × 38.5; width with tabs 59.5. OEM original ESC body envelope and tab span. Hole spacing, cable bends and available chassis clearance are separate. mm (L × W × H)Stock
- Battery connector
- IC5Stock
Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.