Search Arrma Granite 3S BLX V3

Explore the catalog

VehiclesArrma Granite 3S BLX V3ESC calibration

Maintenance reference

ESC calibration

Arrma Granite 3S BLX V3 · ARA4302V3

Arrma Granite 3S BLX V3, ARA4302V3; original equipment covered by the cited edition.

← Vehicle service reference

Start with the correct reference

Open the cited manufacturer reference for the assembly, sequence and checks. Replacement needs depend on inspection and the fitted components.

ARRMA BLX100, 3S V3: calibration

Original ARRMA BLX100 AR390069 in the explicitly listed ARA4302V3, ARA4303V3, ARA4312V3 and ARA4306V3 editions.

Before starting

  • Confirm that the vehicle still has the controller covered by this exact manual edition.
  • Raise the wheels clear of the ground when checking the radio equipment. Use a fully charged compatible LiPo battery.

Calibration sequence

  1. With the ESC off, connect the batteries and switch on the transmitter.
  2. Hold the SET button while switching on the ESC. Release SET when the red ESC LED starts flashing.
  3. Leave the trigger at neutral and press SET. Confirm one green flash.
  4. Hold full forward throttle and press SET. Confirm two green flashes.
  5. Hold full brake and press SET. Confirm three green flashes.
  6. Switch off the ESC to finish the setup.

Final checks

  • Return the trigger to neutral before switching on for use.
ARA4303V3; ARA4312V3-manual-multi.pdf, PDF p. 15

Parts, tools and consumables

No separate parts or tools are listed here. Check the cited instructions for consumables, tools and replacement decisions.

Part links open an exact-model OEM listing. Quantities, reused hardware and condition-dependent replacements may need checking in the manual. A listed part is not an instruction to replace it.

Setup specifications

ESC
ARRMA BLX100Stock
Sources
ESC rating
100 A continuousStock
Sources
ESC mounting dimensions
43 × 54.5 × 34. Original BLX100 envelope, including hold-down tabs in the width. Mounting-hole spacing and available chassis clearance are separate. mm (L × W × H)Stock
Sources
ESC motor connector
4 mm bullet. Original BLX100 motor-side bullets; battery EC5 connector is separate.Stock
Sources
Battery connector
IC5Stock
Sources

Keep the axle positions and original units shown. Values describe the cited configuration. Replacement-derived and community figures keep their stated basis.