BSx4S-one10 Grasper2 DRIFT SPEC

Specifications

最大トルク @ 7.4V時

• 16.0Kg・cm 最高スピード：0.09sec/60°

最大トルク @ 6.0V時

• 12.1Kg・cm 最高スピード：0.11sec/60°

Dimensions

• 40.5×26×21mm（ロープロタイプ）

Weight

• 51.0g

Cable & connector

• Cable length: 180mm（コネクタ部除く）

Power supply

• 6.0～7.4V

Published component mode or construction

• ブラシレスモーター

Published component mode or construction

• シリアル対応

Construction

• Gear material: Hard-anodized aluminum gears

Bearing arrangement

• Dual ball bearings

Gear shaft

• Hard servo gear shaft (manufacturer wording)

Top case material

• Aluminum

Middle case construction

• Aluminum heat-sink middle case

HCS support

• Supported

Drift preset performance condition

• Drift preset parameters may not produce the listed maximum torque or maximum speed

Published serial setup

• EX-NEXT XT mode with servo connected to KR-420XT B/S port

HCS channel setup

• Connect to receiver channel 1-4 configured for HCS mode

Signal mode selection

• Automatic according to receiver port and mode setting; no separate mode-setting accessory required

Parameter programmer

• LCD Expansion Unit 2 EXP-201

EXP-201 programmer power and lead requirement

• Separate 6-7.4 V power supply and Y-lead required

Model selector requirement

• Servo Model Selector for 4S; legacy No.61029 is not supported

Serial gyro interposition constraint

• Serial communication is not supported with an intervening gyro such as KG-X between receiver and servo

Telemetry gyro interposition constraint

• EX-NEXT telemetry is unavailable with an intervening gyro such as KG-X; use Servo Model Selector for 4S

Packages

Vehicle applications

No vehicle applications recorded.

Search other recorded listings