MC340CR

Specifications

寸法/重量

• 36.5ｘ32.0ｘ18.0㎜/39ｇ

Motor requirement

• Brushed motor, 12T or higher; brushless motors unsupported

Supported drive batteries

• 7.2V Ni-MH, 7.2V Ni-Cd or 7.4V Li-Po

Forward-side current / peak

• 60A / 360A

Reverse-side current / peak

• 30A / 180A

BEC

• output: 6V / 3A

Water resistance

• Splash and dust resistant; not fully waterproof

Receiver response-mode restriction

• SR and UR modes unsupported

Initial transmitter setup

• Throttle D/R, EPA and ATL 100%; trim/subtrim 0%; ABS and brake mixing disabled; throttle direction normal

Startup neutral detection

• Automatic neutral detection; leave throttle untouched for approximately 3 seconds after power-on

Jumper-selected drive modes

• Forward/brake/reverse with 50% reverse; forward/brake without reverse; linear forward/reverse with 100% reverse

Battery-type selector

• Set the battery jumper for the selected Ni-MH/Ni-Cd or Li-Po battery; change jumpers only with ESC off

Thermal protection

• Above 100°C internal temperature, motor voltage is halved; further heating shuts down output; restart requires 80°C or lower

Low-voltage response

• Ni-MH/Ni-Cd: reduced motor voltage followed by shutdown as voltage falls; Li-Po: shutdown

Packages

Vehicle applications

No vehicle applications recorded.

Search other recorded listings