– Dedicated RC drift car setting – Remote gain function and mode switching function – Integrated, compact, and light weight – Easy setup – Supports S.Bus/S.Bus2 Connection
OPERATING VOLTAGE
DC 4.2-8.4V
Dimensions
20.5 mm x 20.5 mm x 11 mm 0.8 in x 0.8 in x 0.43 in
Weight
3.7 g 0.13 oz
Gyro sensor
MEMS vibrating structure rate gyro
Current drain, excluding servo
30 mA
Operating temperature range
-10 to +45 °C
Receiver requirement
Futaba receivers only
Steering servo requirement
Futaba digital servo; analog servos cannot be used
Remote gain requirement
Transmitter with at least 3 channels and adjustment of gain channel
UR mode
Not compatible
S-FHSS receiver input mode
Use transmitter analog-servo mode with S-FHSS receiver; servo connected to gyro must still be digital
Gyro ports
Port 1: steering/S.BUS input; port 2: gain input; port 3: steering-servo output
Low-battery indicator threshold
Below 3.8 V; indicator, not a battery cutoff specification
Supplied accessories
Mini screwdriver; sensor tape; extension cords; nylon straps
SR servo selection condition
Set SR ON only with an SR-capable servo; use SR OFF for a normal digital servo
Initialization time and condition
3-5 seconds after receiver power-on; keep vehicle and transmitter steering wheel stationary
